Telephone: 530-274-FUEL or 530-274-3835
  • Search

DMPE Littlefield 2" Set Back Blower Plate

Price:
$400.00
Part No.:  1100-0020A
Qty:
RBS on FaceBook
This part was designed to be used with the pie shaped open bottom blower and makes moving your blower on a conventional blower manifold a snap. It is made from 1/2" alum. plate and uses 7/16" flathead bolts to mount the plate to the manifold, then a set of holes are drilled back 2.00" inches from the stock locating holes to move the supercharger back sealing the blower up on the manifold and helping the distribution of the discharge from the supercharger to be more centrally located in the manifold.

Also the plate has been O-ringed on the blower side and includes a set of flathead bolts to mount to the manifold and O-ring.

RBS can supply the customer with blower studs if needed. The plate has been anodized to help prevent galling and the plate has been machined to lighten it up to keep the weight down on your hot rod.

To measure if this set back plate will work for your application the racer will need to measure from the center of the left most forward bolt hole on the blower snout side of the supercharger case to the end of the case. The measurement on the blower case should be 1.625" to use this set back plate. If the measurement is 2.625" this plate will not work on 1" to the front blower cases.