RBS has had customers ask to move the barrel valve back on the front of long tube injectors so the barrel valve plumbing was not all over the hood of the race vehicle. With this nice simple billet bracket it allows the racer to move the barrel valve five inches backwards on the injector. This bracket mounts to a JBR or Gorr injector that uses an alum. front butterfly faceplate with two 1/4" mounting studs and will allow the racer to mount any Enderle, Gorr, Stewart, Pete Jackson or any other barrel valve that uses the industry standard two 1/4" mounting studs. The bracket is counterbored so mounting the bracket is clean and the rear holes are drilled and tapped 1/4-20 to make mounting the barrel valve a snap. Mounting hardware is included to mount the barrel valve and the bracket.