Telephone: 530-274-FUEL or 530-274-3835
  • Search

SOLD Used 5.00" Alum. Roots Blower Snout Assm. SSI/Retro

Used 5.00" alum. roots blower snout assembly. Blower snout includes a snout coupler that was set up for a 6-71 thru 16-71 roots retro or SSI supercharger. Grade eight snout mounting hardware included.

Shaft is made from heat treated steel and is 1.250" dia. with twenty four splines. Register for blower pulley on the front of the shaft is 2.00" and uses the industry standard six .375" bolts on a 2.782" bolt circle.

Snout housing is billet alum. that is machined down to accept a RCD snout clamp that allows the racer to mount a belt guard or starter face plate and uses an O-ring to insure proper seal to the blower front cover.

Snout includes grade eight mounting hardware. Snout fits 6-71 thru 14-71 retro roots Littlefield, Hampton, Mooneyham, BDS, Blower Shop, Kuhl, or GMC blowers as well as SSI, DMPE, or Fowler superchargers.

Retro blowers have a 2.00" thick front bearing plate and gear register is 1.50" on the snout coupler. If using on a DMPE or Kobelco buyer may need to purchase a coupler register sleeve.

Driveshaft could be cut to length by the buyer if snout is to be run on a conventional Littlefield, Hampton, Mooneyham, BDS, Blower Shop, Kuhl, or GMC blower.

Note: This is a used item.  This item might have been taken in on a trade. RBS may have inspected this item and deemed re-usable. There is no warranty expressed or implied with this item.