Used SSI roots blower snout drive shaft. Blower drive shaft is made from heat treated chromoly steel that has been gundrilled down the center to lighten up the weight of the shaft.
Shaft measures 1.250" and is 48 tooth fine spline. Register on the shaft is 2.00" with six 3/8-24 bolt holes on a 2.782" bolt circle which pretty much is industry standard. Fits most all SSI blower snouts but be sure to measure using the measurements below to know if it will work for yor application.
To make sure measure from end of spline to bearing surface, this shaft measures 3.120", from bearing surface to snap ring groove is 1.50" and shaft is designed to ride on dual ball bearings.
Note: This is a used item. This item might have been taken in on a trade. RBS may have inspected this item and deemed re-usable. There is no warranty expressed or implied with this item.