PSI Screw Blower Alum. Relief Cut Blower Stud 1.750"

Categories:
Superchargers
Studs
Supercharger Componets
PSI

For the racer that has a PSI screw blown Noonan Hemi with a billet blower manifold that has the fuel distribution plate machined into the top of the manifold RBS carries the correct blower studs for the application. Don't worry about cutting, grinding or sanding these are ready to go and your finger tips will thank you.

Stud is made from a 7075 alum. that has been anodized for wear resistance and has relief machined in the shank of the stud to allow the stud to break before damaging the supercharger case. The stud has 7/16-14 threads on the manifold side and standard 7/16-20 for the manifold nuts.

Studs fit most PSI screw blower. Stud length is 1.650" not including the top, including the starter top 1.750".

Starter tip of blower stud is .100", fine thread is .600", shoulder is .550" and coarse thread is .500".

Studs are sold individual. RBS also can supply7/16 AN washer #420-0007 and 7/16-20 12 pt. nut steel #450-0017TP.