If routing plumbing thru a firewall, motor plate, or most any flat panel and needing to route the line in a 90 degree once thru the plate this AN male flare bulkhead is the answer you are after. The one side of the fitting is longer allowing the use of a bulkhead nut to secure the bulkhead fitting securely thru the plate that the racer is running the bulkhead thru, then on the other side it allows the racer a sharp 90 degree to connect the AN line to.
Machined from alum. and anodized for corrosion protection both ends are male 37 degree AN thread. One bulkhead nut is included.
Note: This is a used item. This item might have been taken in on a trade. RBS may have inspected this item and deemed re-usable. There is no warranty expressed or implied with this item.
Note: This is a used item. This item might have been taken in on a trade. RBS may have inspected this item and deemed re-usable. There is no warranty expressed or implied with this item.
Cart
copyright © 2024