Telephone: 530-274-FUEL or 530-274-3835
  • Search

Used PSI Low Profile Mag Injector Assm.

When we got this injector it was crusty and ugly. We gave it a complete restoration starting with being re-polished, new Dow-7 coating and brand new bearings installed to give the racer a nice looking and functioning injector.

What you see here is a low profile PSI injector that is made of cast magnesium, is very lightweight, O-ringed on the bottom giving the injector a superior seal to the top of the blower and Dow-7 coating is beautiful goldish green.

This injector is low profile and ideal for cars where vision is an issue. With this design of a hat it is 3.750" tall and works well on a roots blower with an injector adpt. The injector assm. includes a injector housing, throttle shaft, throttle stops and butterflies. The injector weights eight pounds and has two small air holes drilled that were used for air bleeds that will have to have tape put over them or set the butterflies up to run with the air holes open.

The butterflies are installed gold anodized side out but the other side has been polished so if the buyer likes flip them around and sport the polished butterfly look. This injector is great for a dragster, funny car, or pro mod. Two air holes can be seen next to the center mounting bolt towards the front of the injector.
Fits B, C, D or H PSI screw blowers.

Note: This is a used item.  This item might have been taken in on a trade. RBS may have inspected this item and deemed re-usable. There is no warranty expressed or implied with this item.