Hemi Mag Drive Bronze Gear & Oil Pump Driveshaft Mallory/FIE

*** IN STOCK SHIPS TODAY *** NOTE 5/16” HEX PROTION OF DRIVESHAFT TENDS TO RUN CLOSE TO .315” SO A SMALL MASSAGE MIGHT BE NECESSARY TO DROP INTO YOUR .312” FEMALE HEX OIL PUMP *****

This bronze drive gear/oil pump driveshaft is used with most #2500-0027F Gen 2 Hemi FIE/Mallory single Hemi mag drives or MSD's #2500-0008F cam sync. plug assm.

It uses the industry standard heat treated .500” steel shaft that has had the bronze gear pinned to the shaft and is 5/16” hex on the end to drive most all industry standard oil pumps.

The female drive tang up top on the shaft is .150" wide and .500" long . It is the flat type that the mag drive shaft sets into once it is all place down in the engine block.