*** IN STOCK SHIPS TODAY *** RBS is excited to offer the racer these new Hemi refill plug wire kits from FIE which offers more benefits at less cost to the racer when there plastic plug tubes are still good and just the plug wires are needing to be replaced. The racer has there choice in color and suppression or solid core. Here is the low down on the wires and allow yourself the advantage of these new plug wire sets to quicken ET and add mile per hour to your time slip.
SUPRESSION: Wire sets are made by FIE in-house using top quality 8.2mm Taylor Thunder-Volt 50 wire. At only 40 ohms per foot, these racing suppression sets are MSD Pro-mag compatible and can be used with Super-Mags, Sprint mags and Vertex mags where tachometers, data loggers and other noise-sensitive equipment is used while keeping output to the plug as high as possible.
SOLID: These sets are made by FIE, in-house using top quality 8mm Taylor solid core wire. If you do NOT run electronics on-board (tach, shift-light, data logger, etc.), these are the wires you want for your magneto. With ZERO impedance, these wires deliver every volt to the spark plug. Not compatible with electronic box type ignitions or MSD Pro-Mags!
All eight wires are six foot allowing for different mag mounting scenarios so you won't come up short when going to make that last wire on Friday night. The straight plug terminals and boots are installed for you. Trim to fit and terminate the magneto end yourself using the supplied double-crimp terminals and black HEI boots.
Since there's a extra wire here, FIE decided to include four extra boots and terminals (not shown). You can use them for spares, or assemble two extra spare coil wires for yourself to have at the track ready to go.
Wire set does not include MSD 90 degree spark plug tubes or Mallory Hemi spark plug tubes.