Telephone: (775) 461-0954
  • Search

Barrel Valve Re-Locater 4.00"

*** IN STOCK SHIPS TODAY *** RBS has had customers ask to move the barrel valve back on the front of long tube injectors so the barrel valve plumbing was not all over the hood of the race vehicle. With this nice simple billet bracket it allows the racer to move the barrel valve four inches backwards on the injector.

This bracket mounts to a Specialty/JBR injector that uses an alum. front butterfly faceplate with two 1/4" mounting studs and will allow the racer to mount any Enderle, Gorr, Stewart, Pete Jackson or any other barrel valve that uses the industry standard two 1/4" mounting studs.

The bracket is machined so mounting the bracket is clean and the rear holes are drilled and tapped 1/4-20 to make mounting the barrel valve a snap. Mounting hardware is included to mount the barrel valve and the bracket as well as a link bar with heims to make connecting the barrel valve spool to the linkage arm an easy installation.

Linkage is 6.750" center to center adjusted all the way in. Racer can adjust out at least another 1.00" if more length is needed.

Powered By Zomix Content Management Systems copyright © 2022