Barrel Valve Re-Locater 4.50"

*** IN STOCK SHIPS TODAY *** LEFT & RIGHT ARE IF YOU ARE STANDING IN FRONT OF THE MOTOR AND THE INJECTOR IS FACING FORWARD ON A LEFT SIDE DRIVEN CAR, LEFT BRACKET WILL BE PASSENGER SIDE 2,4,6,8, SIDE OF MOTOR, RIGHT SIDE WILL BE DRIVER SIDE 1,3,5,7.

RBS has had customers ask to move the barrel valve back on the front of long tube injectors so the barrel valve plumbing was not all over the hood of the race vehicle. With this nice simple billet bracket it allows the racer to move the barrel valve 4.50" backwards on the injector. Made from .500" billet alum, anodized finish with a nice lightening pocket machined into it to keep the hot rod lightweight.

This bracket mounts to a CG, Bohr, JBR or Specialty injector that uses an alum. front butterfly faceplate with two 1/4" mounting studs and will allow the racer to mount any Enderle, DMPE, Stewart, Pete Jackson or any other barrel valve that uses the industry standard two 1/4" mounting studs.

The bracket is counterbored so mounting the bracket is clean and the rear holes are counterbored to drop a bolt into to make mounting the barrel valve a snap with a lock nut on the other side of the barrel valve. Mounting hardware is not included to mount the barrel valve and the bracket.