RBS SUPERCHARGERS IS CLOSED UNTIL DEC 5TH.
Online ordering will be available from November 25th, - Dec 5th. No phone or email will be available at this time. We apologize in advance, for any inconvenience this may cause and look forward to welcoming you back on December 5, 2024.

Bell Housing Stud Hemi Stepped 3/8" x 7/16"

Categories:
Fasteners
Studs
SPECIALTY FASTNERS

*** IN STOCK SHIPS TODAY *** If you have a late style aluminum Hemi engine block with the 7/16" thread in the bellhousing mounting area, but don't want to drill your motor plate and bellhousing out for the larger thread, RBS is here to help.

We have a stud that is not only macined out of quality steel, but is heat treated and ionized for thread protection as well. All of this means a quality hi-strength mounting stud that will withstand the abuse of dragging your bellhousing over the threads time and time again, but will also cure the problem of a step stud for your application.

The block end is 7/16" coarse thread and the other end is 3/8" fine. The thread lengths are .700" on the 7/16" end, there is a .250" long 7/16" dia. shoulder, .425" 3/8" dia. shoulder and the 3/8" fine thread is .550". Stud overall length is 2.250", thread to thread is 2.00'.

These are perfect for any application where you need a step stud or in a place where you needed to open a thread to 7/16" for a damage repair. These are manufactured as bellhousing studs but could be used anywhere on the race car.

Most Hemi blocks use nine bell housing studs.